This website uses cookies primarily for visitor analytics. Certain pages will ask you to fill in contact details to receive additional information. On these pages you have the option of having the site log your details for future visits. Indicating you want the site to remember your details will place a cookie on your device. To view our full cookie policy, please click here. You can also view it at any time by going to our Contact Us page.

UK HSE fines company after workers fall ill following exposure to chemical spill

12 March 2021

The UK Health & Safety Executive (HSE) has fined the fabrication division of Nasmyth Technologies Limited after four employees were exposed to hazardous substances that caused significant ill health and time off work in 2017.

Image: HSE
Image: HSE

Nasmyth Technologies pleaded guilty to breaching Section 2(1) of the Health & Safety at Work 1974 Act and was fined £13,000 and ordered to pay costs of £9,551 at Poole Magistrates’ Court. The HSE investigation into the incident found that there was significant non-compliance regarding management of substances hazardous to health.

Poole Magistrates’ Court heard how, on the 9 October 2017, between 150 and 200 litres of a chemical preparation, that included hydrofluoric acid, spilled across a large area of the factory floor in Wimborne, Dorset. Four workers were involved in the clean-up that took several hours. They were provided with inadequate personal protective equipment (PPE) and respiratory protective equipment (RPE) to undertake a clear up, for which they had no training.

Some of the employees suffered ill health following the incident, including an asthma attack, a severe headache, nausea, sore eyes and throat. One of the workers, whose symptoms persisted, was referred by his doctor to a specialist for treatment.

The HSE investigation found that the company had failed to carry out a suitable and sufficient assessment and had not prepared for this emergency situation. One of the failings was that the RPE (face masks) provided did not have the correct type of filter for protecting against hydrofluoric acid gas. Additionally, the type of RPE provided to workers relied on a good seal against the face in order to protect workers and no face fit tests had been undertaken to ensure the masks fitted the workers’ faces. Furthermore, workers were unshaven meaning their beards or stubble prevented an effective seal of the RPE to their faces.

Speaking after the hearing, HSE inspector Berenice Ray said: “This incident could have so easily been avoided had the company firstly undertaken a suitable and sufficient risk assessment and then implemented the necessary controls, including emergency arrangements for dealing with a chemical spill and the provision of instruction and supervision to ensure safe working practices are followed. Companies should be aware that HSE will not hesitate to take appropriate enforcement action against those that fall below the required standards.”


More information...

Contact Details and Archive...

Print this page | E-mail this page