Bulldog conveyor belt alignment and rip detection switch
30 September 2010
4B Braime Elevator Components have launched the 4B Bulldog belt alignment and rip detection switch. This electro-mechanical system has been designed to detect dangerous misalignment of the conveyor and also detection of belt tear damage.
The switch will detect horizontal misalignment of belts when contact is made with the roller; the roller arm will be forced to pivot by the belt activating a switch at 15º to trigger an alarm, and 30º to trigger a shut down procedure of the conveyor. The sensors are usually installed in pairs on opposite sides of the belt.
A steel flexible wire is set below the running conveyor belt approx 20-30mm attached by a rare earth magnet at each end. If the belt is ripped or damaged the wire is pulled away releasing the magnet connection which in turn will activate a switch.
The Bulldog’s robust design makes it suitable for the use in heavy duty applications such as quarrying and mining. It is easy to install and doesn’t need calibrating. The Bulldog is compatible with 4B’s CBS2 belt alignment monitor and the Watchdog Elite monitoring system. It has been approved for use in hazardous areas according to ATEX.
Contact Details and Archive...